so, as some of you may know i bought ben steiners 1st gen crx it recently started slipping the clutch, and the turbo blew up right before winter so i decided i would fix it this winter as a project. well i got the transmission off without an issue and it all came apart. the flywheel was garbage just about through to the rivets on the clutch disc and flywheel. the pressure plate was intact just had a lot of grooving so i ditched all of it and since then bought a clutch off of maec that would have worked if the spline count on my transmission wasn't 19, which is where i run into my problem if im not mistaken everywhere including carquest, oriellys all of the places ive looked says with the 89' acura integra d16a1 the transmission is a 21 spline transmission shaft. well my transmission is a 19 spline output shaft. so i have no idea what transmission i have or what clutch to even order. would like to get this done asap so i can go throw it through some corners at the auto x events with you guys any help would be appreciated. I also have a 220mm flywheel and pressure plate would a 200mm clutch disc work with those or would it be too short on the inside diameter of the flywheel? thanks.